IMCA Safety Flash summarize key safety matters and incidents
Capstan showing parted wire
IMCA has issued Safety Flash to summarize key safety matters and highlight lessons learnt from incident in which capstan wire parted during deployment of anchor buoy.
The incident occurred when a vessel was involved in a Delta Flipper anchor drag test operation. The operation consisted of deployment one after the other, of an anchor buoy and a Delta Flipper type anchor, using two capstan wires, and then recovery back to deck using the main tow wire.
Three tests were carried out successfully. During the fourth test, the port side capstan wire parted whilst dragging the anchor buoy on deck. There were no injuries.
Investigation noted the following:
- A clear deck policy was constantly followed;
- The certified safe working load (SWL) of the capstan wire was below the rated pull;
- Tear and wear – friction of capstan wire rope on the edging of capstan flanges;
- There had been no visual checks for tear and wear of wires made by the crew after each anchor drag test;
- Another, more preferable and safer, option of using tugger winches had not been considered for this operation
Lessons Learnt
- SWL requirements should always be considered when rigging/towing operations on deck. Ensure that the capstans rated pull is below the certified SWL of the capstan wire. The capstan should stall before the wire fails;
- Anchors should be moved on deck only with tugger wires connected either through towing pins or snatch blocks fixed on the pad eyes next to the stern roller, ensuring that all pinch points for the wires are identified and avoided;
- Capstan winches should not be used as a substitute for a deck tugger;
- When using capstans, care should be taken with wire lead in and lead out angles to avoid wire abrasion from the capstan flanges;
- Avoid excessive wraps on the capstan drum which would cause knifing damage of the wire and subsequently reduce the wire SWL;
- Visual checks: checks of the tugger/capstan wires and other rigging/towing equipment should be carried out by the crew before every test, and checks made of wire ropes SWLs on other anchor handling tug supply (AHTS) vessels for any wire underrating issues to identify/investigate and address each particular case;
- Vessel should carry at least one spare tugger and certified capstan wire to allow replacement of damaged wires immediately;
- Revised risk assessment for anchor drag test operations to include identified additional hazards and control measures;
- Ensure vessel personnel involved in rigging and lifting operations receive appropriate training;
- Design/size of the stern roller to be adequate to allow the Delta Flipper type anchor to go through it easily without getting stuck.
|
Source & Image Credit: IMCA