SMART4SEA Conference & Awards

31 Jan 2017
Learn More
SMART4SEA Conference & Awards

31 Jan 2017
Learn More

Following SMS procedures may prevent accidents

safety

The USCG has issued safety alert regarding a recent incident that occurred while a bulk carrier was at anchor off the coast of Texas. Specifically,  a crewmember that could not swim was put over the rail in a Bosun’s Chair to paint the vessel’s mid-ship draft marks and load lines. Unfortunately, the Bosun’s Chair line parted and he fell into the water.

The man survived the fall and attempted to swim towards a life ring that had been thrown to him, but he ultimately submerged and was lost. Other crewmembers attempted to launch a rescue craft, but it failed to operate.

Putting a crewmember over the rail to paint while a vessel is at anchor is a typical shipboard operation, and this instance is a classic example of where following SMS procedures could have prevented a death or injury. Investigators found that the Captain and Chief Mate had met and developed a suitable work plan. This information was later communicated from the Chief Mate to the crewmembers involved. The plan had several important elements, including inspecting the Bosun’s Chair and manila rope rigging and requiring that the crewmember going over the rail wear a personal floatation device (PFD) and use a safety harness and lifeline; however, the plan was not implemented.

Crewmembers failed to adequately check the strength of the Bosun’s Chair line, instead simply pulling on it. Also, the deceased crewmember was not wearing a PFD, and, even though he wore a safety harness along with a lifeline, the lifeline went untended and was not tied off to the vessel. The vessel’s Bosun was not present, and it remains unknown as to who was supervising the operation. Finally, months before this tragedy, the Chief Mate had placed a requisition request for new manila line and for PFD work vests that were designed to be worn with the vessel’s safety harness; however, the request went unfilled.

Recommendations
• Properly use safety equipment.
• Ensure adequate supervision of work teams.
• Develop workplace mindsets that properly develop and execute plans, including those for worst case scenarios.
• Implement barriers to prevent such scenarios.
• Fully implement and adhere to Safety Management System requirements.

Further information may be found herebelow

Source: USCG

Related Posts


Share on Facebook0Tweet about this on TwitterGoogle+0Share on LinkedIn17

Leave a Reply

Your email address will not be published. Required fields are marked *

*

Explore Our Group Sites:

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this. By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this. By continuing to use the site, you agree to the use of cookies.more information

Close